Katronic Technologies FLUXUS ADM 6725, Operating Instruction

Page: 61 / 148

ADM 6725 E10

KA T
6 - 1
Program Branch OUTPUT OPTIONS
6 Program Branch OUTPUT OPTIONS
In this program branch, the following output options can be set-up/operated:
•
Selection of the quantity and unit of measurement
•
Set-up of the damping factor for the measured value
•
Storage of measuring values (data logger)
•
Activation of the serial interface
•
Set-up of the storage interval
•
Set-up of current loop (optional; chapter 13.1.2)
•
Set-up of voltage output (optional; chapter 13.1.3)
•
Set-up of frequency output (optional; chapter 13.1.4)
•
Set-up of pulse output (optional; chapter 13.2)
•
Set-up of alarm outputs (optional; chapter 13.3)
The following output options are described in this chapter:
•
Selection of the quantity and unit of measurement
•
Set-up of the damping factor
•
Storage of measuring values (data logger)
•
Activation of the serial interface
•
Set-up of the storage interval
The set-up and operation for the various inputs/outputs, called the process interfaces,
are explained in chapter 13.
Note: Frequently used output options are pre-programmed. Thus, you may start the
measurement without going through the program branch
OPT .