Katronic Technologies FLUXUS ADM 6725, Operating Instruction

Page: 55 / 148

ADM 6725 E10

KA T
5 - 13
Program Branch MEASURING
5.0 cm/s
+Cut-off Flow
Enter here the cut-off flow limit for positive
measuring values. Should the measured value
fall below this threshold, a flow velocity of 0
cm/s will be used for further calculation.
-5.0 cm/s
-Cut-off Flow
Enter here the cut-off flow limit for negative
measuring values. Should the measured value
rise above this threshold, a flow velocity of 0
cm/s will be used for further calculation.
In mode Cut-off flow/>ABSOLUTE<, only one limit value has to be entered for the cut-off
flow function:
5.0 cm/s
Cut-off Flow
The limit comparison will be performed using
the absolute numerical value of the measured
flow velocity.
Note:
For the user definition of the cut-off flow limit, the conventions applicable for the
SUPER USER MODE (see introduction in chapter 9) are valid.
5.3.4 Flow Totalisers
FLUXUS has the facility to work as a flow totaliser. There are two flow totalisers in-built.
One counts the total quantity throughput in positive flow direction, the other counts in
negative flow direction.
Flow totalising for each independent measuring channel means:
•
FLUXUS measures the liquid volume throughput which has passed the respective
measuring point within a given time.
•
The corresponding unit of measurement, which was defined in program branch
OUTPUT OPTIONS, will be used for totalisation.
54.5 m3/h
A: Volume Flow
M8
The two in-built flow totalisers can be
activated at the same time from display
'Volume Flow':
Press
O N
O
to activate the flow totalisers.
Attention!
•
Activate the flow totalisers only after the first measuring value has been
displayed. Otherwise, there will be no counting up.
•
To activate the flow totalisers for a certain measuring channel , this channel
must be shown on the display.
54.5 m3/h
A: 32.5 m3
M9
Here you can see on the display the totalised
flow volume which has passed the measuring
point in one flow direction since the activation
of the totalisers.
FLUXUS can also show the respective flow volume with alternating flow directions: