Katronic Technologies FLUXUS ADM 6725, Operating Instruction

Page: 39 / 148

ADM 6725 E10

KA T
4 - 7
Program Branch PARAMETER
Attention! The roughness may be entered within the range from 0 to 5 mm. Otherwise, an error
message appears (see page 4-1).
4.3 Input of Medium Parameters
Medium parameters required for measurement are:
•
Minimum and maximum sound
velocity of the medium
•
Density of the medium
(only if output option
mass flow is activated)
•
Kinematic viscosity of the medium
•
Temperature of the medium
(Table 4 in chapter 17 gives an overview of pre-programmed parameters for those media which are often used.)
Medium
"
P11 Select from this scroll display
group the medium you want to
measure.
Confirm by pressing ENTER .
#
Water P11-1
#
Petrol P11-2
#
Ether P11-3
#
Methanol P11-4
#
Acetone P11-5
#
Toluene P11-6
#
HCL 37% P11-7
#
Glycol P11-8
#
Vinylchloride P11-9
#
Milk P11-10
#
BP Transcal LT P11-11
#
BP Transcal N P11-12
#
R22 Freon P11-13
#
CaCl2 -45 C P11-14
#
CaCl2 -15 C P11-15
#
R134 Freon P11-16
#
H20-Ethan.-Glyc. P11-17
#
Oil P11-18
#
Ammonia (NH3) P11-19
#
Shell Thermina P11-20
!
Other Medium P11-21
Next display
P16 (Without pressing ENTER,
the displays scroll around)
If the medium has been selected, FLUXUS jumps straight to the display for
entering the
medium temperature . If the list does not contain your lining material,
the set-up can be done as follows:
Other Medium
Medium
"
P11-21 Scroll through to the display
'Other
Medium' .
Confirm by pressing ENTER .
Now, FLUXUS requests the input for the medium parameters min.
and max. sound velocity, kinematic viscosity and density.