IAI MCON-C, Instruction Manual

Page: 78 / 480

68
3.2 Initial Setting
The operation mode is to be set using Gateway Parameter Setting Tool (Ver. 2.1.0.0 or later).
(Ver. 3.1.0.0 or later for CC-Link IE Field Type) Setting of the parameters including the
operation pattern are to be conducted on RC PC Software (Ver. 10.0.0.0 or later).
Shown below is the process for the setup. Follow the instruction to conduct the setting
properly.
(Preparation) Install RC PC Software and Gateway Parameter Setting. For Gateway
Parameter Setting Tool, install the file stored in the CD-ROM for PC software,
or download from our website, intelligentactuator.com.
[Refer to the instruction manual of the PC software for the details of the PC
software.]
Make sure the system I/O connector wires and operation mode setting switch are in MANU
condition when having the setting done. [Refer to “Name and Function of Each Part 9), 11)”]
3.2.1 Operation Mode Setting (Setting in gateway parameter setting tool)
[Step 1] Connect between the PC and SIO connector on MCON with the cable enclosed in
the RC PC Software, and start the gateway parameter setting tool. The following
window appears. Select “MCON” and click “OK” button.
[Step 2] Once MCON is detected the detected unit numbers become available to select.
Select the unit number to be connected and click the “OK” button.
MCON being detected Select the unit number to be connected
3.2 Initial Setting