A–10
director product manager user guide
Information and Error Messages
Cannot start port
diagnostics.
Port diagnostics
cannot be started at
the Product Manager
application because
the Ethernet link is
down or busy.
Retry the operation later. If
the condition persists, contact
the next level of support.
Cannot swap an
uninstalled port.
A port swap cannot
be performed when
the port card is not
installed.
Perform a swap only on a port
that is installed.
Click OK to remove
all contents from
log.
This action deletes all
contents from the
selected log.
Click OK to delete the log
contents or click Cancel to
cancel the operation.
Connection to
HAFM server lost.
Click OK to exit
application.
The HAFM
application at a
remote workstation
lost the network
connection to the
HAFM server.
Start the HAFM application to
connect to the HAFM server.
Continuing may
overwrite host
programming.
Continue?
Configurations sent
from the host may be
overwritten by HAFM.
Continuing will activate the
current configuration, which
may have been configured by
an S/390 host.
Could not export
log to file.
A log file I/O error
occurred and the file
could not be saved to
the specified
destination. The disk
may be full or write
protected.
Ensure file name and drive
are correct.
Could not find
firmware file.
Firmware file
selected was not
found in the FTP
directory. Or, the
selected file is not a
firmware file.
Ensure file name and
directory are correct. Or,
obtain a valid firmware file
from your service
representative.
Table A–1: Product Manager Messages (Continued)
Message Description
Action
