director product manager user guide
5–9
Using Maintenance Features
Use the following steps to reset the configuration parameters on the director to the
default values.
1. Choose Reset Configuration from the Maintenance menu. The following
warning displays:
WARNING: This operation will reset all director configuration data and
nonvolatile settings to factory default values. The director must be offline to
continue.
2. Set the director offline. For instructions, refer to “
Set Online State
” on
page 5–4
.
3. To continue the reset operation, click Reset on the Reset Configuration dialog
box. If you want to cancel the operation, click Cancel.
NOTE: If you have enabled features that add additional port function since the director was
shipped from the factory, these features will be disabled (factory default) when the
configuration is reset. Only those ports that were enabled at the factory will function. You
will have to enable the additional port function features again through the Configure
Feature Key dialog box.
NOTE: Factory-default values may vary, depending on the firmware release installed in
your director. For a list of values, refer to the hp StorageWorks director 2/64 service manual
for the Director 2/64 and the hp StorageWorks director 2/140 service manual for the
Director 2/140.
Table 5–1: Data Default Values
Configuration
Description
Default
Identification
Director Name
NULL string
Director Description
“Fibre Channel Director”
Director Contact
“End User Contact (please
configure)”
Director Location
“End User Contact (please
configure)”
Ports
Port Names
NULL strings
Port Blocked States
Unblocked
Extended Distance
(10-100km)
Disabled
LIN Alerts
Disabled
Port Address
Port number plus 4
