3–14
director product manager user guide
Configuring the Director
— Set All to 1 Gb/sec - Sets the port optics to a 1 Gb/sec data rate.
— Set All to 2 Gb/sec - Sets the port optics to a 2 Gb/sec data rate.
— Set All to Negotiate - Allows the port to negotiate the data rate with the
attached device.
NOTE: Your director model, firmware, and port cards may not allow 2 Gb/sec data speeds.
•
Bound WWN
— Bind All WWNs—Places a check mark in all check boxes in this column and
binds each port to the device with the WWN or nickname entered in the
Bound WWN column for that port.
— Unbind All WWNs—Removes check marks in all check boxes in this
column. A device with any WWN can attach to all ports.
— Bind All Ports to Attached WWN—Places a check mark in all check boxes
in this column and binds each port to the device currently attached to that port.
The Bound WWN column will display that device’s WWN.
— Bind Port to Attached WWN—Places a check mark in the check box for the
port where you clicked to display the menu. This binds that port to the device
currently attached to that port. The Bound WWN column will display that
device’s WWN.
— Clear All Bound WWNs—Clears all WWNs listed in the Bound WWN
column.
Configuring Ports in the Open Systems Mode
To configure ports in open systems mode, use the following steps:
1. Choose Ports from the Product Manager menu bar. The Configure Ports dialog
box displays, as shown in
Figure 3–5
.