GRASS VALLEY KARRERA, Installation & Service Manual

Page: 201 / 389

Installation & Service Manual
177
Creating an On Air Relay Tally Calculator Using M/Es or PGM/PST
Selecting an On Air Tally or Tally Calc 1-4 tab delegates the menu controls to the selected
calculator as shown below.
Calc On - Turns the delegated Tally Calculator on or off. When on, the Calculation Enables
button on the separate Relay Assign menu will be activated for that calculator.
Groups Enabled - Reports which Tally Groups are currently assigned for that calculator, by
group letter (A, B, C, D, corresponding to Tally/GPI connectors 1-4 on the rear of the GV K-
Frame XP Video Processor). To Enable a Tally Relay Group, it must first be turned on, using
the Calc On button for that calculator.
The first tally calculator name is fixed to On Air . Since the On Air Calculator is restricted the
Look Ahead and Bus buttons are disabled (grayed out).
Creating an On Air Relay Tally Calculator Using M/Es or PGM/PST
1 If necessary, login to the desired suite ( Eng Setup, Eng Login ).
2 Select Eng Setup, Switcher Tally, On Air Tally to access the On Air Tally menu. The Suite
button for the current suite will be highlighted.
3 Select a Tributary button on the right.
4 Select an
ME
or
PGM/PST
button on the left.
5 Select an Output button to assign that output of the M/E or PGM/PST to that tributary.
The name of the output is displayed on the Tributary button.
6 Repeat the steps above for other Tributaries for all the outputs you wish to assign for
On Air Tally.
• Pressing the None button clears the assignment for that Tributary.
• Pressing the Reset button clears all the assignments to all the Tributaries.