GRASS VALLEY KARRERA, Installation & Service Manual

Page: 150 / 389

Basic Configuration
126
Install Remote Aux Panel Software
Remote Aux Button Descriptions
Aux Panel Row Button Label Description
GV-RAP-100/200 M/E 1 M/E 1 Fixed Output Source (M1 A)
M/E 2 M/E 2 Fixed Output Source (M2 A)
M/E 3 M/E 3 Fixed Output Source (M3 A)
PGM PST PGM PST Fixed Output Source (Pg A)
Hold Source Hold—Other external devices cannot
change the source, e.g. another router
Un-Shift Buttons 1-32 Unshifted mode—Sources 1-32
Shift Buttons 1-32 Shifted mode—Sources 33-64
Key Split Map a different source to the B or key side of the
Video/Key pair (Aux bus must be in paired mode)
Install Remote Aux Panel Software
The NetConfig utility is used to install the Aux Panel software.
1 Install the NetConfig application from the K-Frame Installer (see the
Kayenne/Karrera/GV Korona Release Notes ).
2 Launch the Netconfig application.
3 Select the
Load SW
button (top-left) in the NetConfig application.
4 In the “Select devices to load:” pane, select Switcher , RAP .
5 Select the AMD-DCC6/ASD E27E Aux Panels and NetConfig will search for the panel IP
Addresses.
Result: Located Aux Panels of that type are displayed in the list, right.
6 Select the check box next to the panels to be updated.
7 Select the Load button below the list.
8 Reboot the Aux Panel to complete the installation.
Configure the Remote Aux Panel System
Configure the Remote Aux Panel System through the Product Web Access page.
1 Enter the Aux Panel IP address into your browser.
Result: the Product Web Access page for the Aux Panel is displayed.
2 Select Panel System on the left.
3 Set the parameters by entering values into the fields for Panel Device Name, Asset Tag,
etc.
4 Select the Do reset .
5 Select Save New Settings .
Configure the Remote Aux Panel Network
Configure the Remote Aux Panel Network through the Product Web Access page.