GRASS VALLEY KARRERA, Installation & Service Manual

Page: 309 / 389

Installation & Service Manual
285
Configuring Milliseconds Between Takes
Many modern router control systems no longer require a delay, or less delay, between
takes. The GV K-Frame XP can transmit takes with or without delay, however the external
router control system must also support the faster settings.
1 Verify that the external device supports the number of milliseconds between takes to
be configured in the menu.
2 In the Eng Setup, Router menu, select the 50 , 25 , or 0 Milliseconds Between Takes
button.
Define Routed Source Definitions
The Eng Setup Source Definition menu is used to define routed GV Switcher sources, which
includes specifying which router destination will be associated with each switcher source.
1 Select the Eng Setup , Source Definition in the menu.
2 Select the source to be configured with the router on the left scrolling list.
3 Select the Video Input data pad and enter the number of the input that will be used
with the router video destination.
4 If the routed source will have an associated key signal, touch the appropriate Key Input
button, then touch the Key Input data pad and enter the number of the input that will
be used with the router key signal destination.
Note:
If you assign a key input, the router system needs to be configured to
switch that key destination along with the video destination. Router levels
can be used to accomplish this.
5 Touch the Router type button to identify it as a routed source.
Note:
The adjacent status indicator is green when a router is detected, and
red when there is no response. If red, you should check the GV Switcher or
router system configuration or the physical Ethernet connections.
6 Touch the Router Destination data pad to open the Router Destinations menu. The
Video Processor receives a list of destination from the router and displays them on
scrolling list on the left.