GRASS VALLEY KARRERA, Installation & Service Manual

Page: 166 / 389

Basic Configuration
142
Configure the IP I/O IP Address and Ports
Configure a IP I/O Multicast Video Signal
IP addresses for Multicast must use 224 through 239 as the first octet in the address. A
Multicast signal can then be sent to an Ethernet switch or received to your local device.
Note:
Ethernet switches must have the IGMP Query Server enabled to
receive a Multicast signal.
1 In the Eng Setup, Video I/O, IP Config menu tab, select the Receive IP or Transmit IP data
pad (see SDI/IP Input Output Configuration ) for the IP I/O channel you wish to
configure, enter the Multicast IP address, and select Enter .
2 To set an IP UDP Port, select the UDP Port data pad for the channel, enter a port
number, and select
Enter
.
3 Select the Apply Settings button.
Configure ST 2110-30 Audio Type for Inputs/Outputs
The K-Frame IP I/O Cards can be configured to send or receive in a bit depth of either 16 or 24 bits and a Time Interval
of 1ms or 125 microseconds. The K-Frame switcher does not make conversions of the Bit Depth or Time Interval as
the audio passes through the I/O Cards and the switcher. Therefore the audio format on input to the switcher must
match the audio format at of the output of the switcher.