GRASS VALLEY KARRERA, Installation & Service Manual

Page: 212 / 389

Basic Configuration
188
c Select a CS channel .
The External Device List closes and the Engineering Name is filled in with the ClipStore
External Device name automatically.
To configure a source as a ClipStore Key input (Key input to the ClipStore Video input
created earlier):
7 From the Source List, Select a source.
8 Select the No Key button in the Key Mode (if not selected).
9 Use the default video input (Video In:) or change it using the Video Input data pad.
10 Select the Direct mode button in the Source Type pane.
11 Give the ClipStore key input an Engineering Name if desired by Selecting the
Engineering Name
data pad and entering the name in the pop-up keyboard.
You now have device control over this ClipStore resource, and it can be mapped. Repeat the
preceding steps for each ClipStore channel.
Configure Outputs
Set the switcher outputs that are feeding into ClipStore. By selecting an Aux bus then
touching one of the CS-1 through CS-4 enable buttons, those Aux bus outputs will be
paired. In other words, if you select the output, then Aux 5, Aux 5a and Aux 5b will be paired
as a ClipStore Video/Key pair when the ClipStore button is enabled.
1 Go to the Outputs menu by touching Eng Setup, Outputs.
2 Select the odd numbered output (first Aux bus output assigned for a video/key pair
must be odd/fill) that you wish to use as the input to ClipStore. Then select Aux as the
Output Type and the desired logical Aux bus.
3 Select one of the ClipStore buttons.
4 Repeat the preceding steps for each channel of ClipStore.
Note:
Is is only necessary to configure all channels as video/key if you wish
to record on all channels.
The Engineering Names for each ClipStore channel will appear in the Local Aux area and/or
can be button mapped as desired.
Acquire and Assign CS channels in another suite
1 In the Outputs menu, deselect the CS channels to be acquired.
2 Select a suite ( Suite 1 - Suite 4 ) button to change suite delegation.
3 Re-acquire the CS outputs by Selecting the CS buttons (CS-1, CS-2, etc.).
It is recommended at this point that you save a new Eng Setup file that includes these
changes.