GRASS VALLEY KARRERA, Installation & Service Manual

Page: 187 / 389

Installation & Service Manual
163
Registering System Nodes
Set the RTP Payload Type
1 Select Inputs / Outputs .
2 Select Video , Audio , or Ancillary .
3 Select the Payload Type data pad, enter the Payload Type number in the pop-up
keypad (numbers lower than 96 will return 96 and numbers higher than 127 will return
127).
4 Select Apply Settings (middle right).
Set the RTP Payload Type in Bulk Configuration
RTP Payload Type can be configured for multiple System Inputs/System Outputs in the Bulk
Configuration menu.
1 Select System Input or System Output , then Video , Audio , or Ancillary .
2 Select the Bulk Configuration button.
3 Enter the System Start and System End (top left) parameters (Inputs/Outputs) by
selecting each and entering the number in the pop-up keypad.
4 Turn on the
Payload Type
enable button (lower right).
5 Select the Payload Type data pad (right of the Payload Type enable button), enter the
number in the pop-up keypad, and select Enter .
6 Select Enter in the Bulk Configuration menu (right of the Payload Type data pad).
7 Select Apply Settings in the IP I/O Config menu (middle right).
Set Payload Type to Default
1 Select the System Input or System Output .
2 Select the Payload Type data pad.
3 Enter a . ( dot ) in the pop-up keypad.
Registering System Nodes
When IP addresses have been changed on GV K-Frame XP system components, or new
components are added, the Video Processor Frame needs to know what new addresses it
will use to communicate with those components. This is accomplished by registering those
addresses with the Frame using the GV Switcher menu application Node Settings menus
(see the K-Frame Kayenne/Karrera/GV Korona User Manual ).
Kayenne and Karrera Menu Panel Registration
Registering the Menu Panel (or PC running the GV Switcher menu application) with the
Frame was described earlier (see Establishing Menu to Frame Communication ). The GV
Switcher menu application needs to be in communication with the Video Processor Frame
before other nodes can be registered.
Control Panel Registration
1 Touch Eng Setup , Node Settings , Control Surfaces .