GRASS VALLEY KARRERA, Installation & Service Manual

Page: 190 / 389

Basic Configuration
166
1 Access the Control Panel Web page, by entering its IP address in a Web browser, then
selecting Configuration .
2 Enter the desired values for OLED, Text Display, High Tally, and Low Tally, and then
select Apply .
Engineering Setups
GV K-Frame XP inputs and outputs are connected at the rear of the Video Processor Frame.
These video signals need to be configured to your facility’s requirements. Engineering
Setups defines system component functionality and how it is cabled into a facility.
Engineering setups are intended to be used and maintained by technical staff, and can be
loaded and saved to disk.
The Engineering Setup menus are accessed by touching the
Eng Setup menu button at the
bottom of the screen, and then selecting the appropriate Menu Category button.
Source Definition Inputs
Source definition tells the system which physical inputs or internal signals to use when a
particular external (only) source is selected. The source definition, denoted by an
Engineering ID number, specifies the signals involved, how to process that signal, and what
external devices, if any, are associated with that source. Each GV K-Frame XP Video
Processor has one source definition set, shared by all users of that system (control surfaces
in all suites).
IMPORTANT: To extend the life of display illumination hardware (in
particular the OLEDs), the Control Panel automatically enters a panel
saver state when its controls have not been touched for a specified
time (ranging from 10 to 30 minutes). In the panel saver state all the
Control Panel buttons and displays go dark, except the
Key 1
through
Key 6
and
Key Prior
buttons are illuminated blue and cycle. Touching
any button or control on the Control Panel exits the panel saver state.