GRASS VALLEY KARRERA, Installation & Service Manual

Page: 198 / 389

Basic Configuration
174
outputs for external devices or other specific uses. Output Blanking is provided in the Eng
Setup, Outputs menu to allow this specialized control.
You can also choose to pass ancillary data or regenerate blanking for all Aux or all Fixed
outputs in the Outputs menu. For example, if you selected All Aux Outputs to Pass Ancillary
Data in the Outputs menu, you could then set individual aux outputs to Regenerate
Blanking. This allows fast configuration of a large number of outputs.
Configure Aux Output Blanking
Configure Aux Output Blanking for all or individual Aux outputs to pass or blank ancillary
data in the Eng Setup, Outputs menu.
1 In the Eng Setup, Outputs menu, select either Output or Modular I/O .
2 Select an Aux output from the Physical Outputs scrolling list or select Aux in the Output
Type pane to display the Aux Outputs menu.
3 Result: The Logical Aux Bus selection pane is displayed (center) along with other Aux
output parameter functions.
4 In the All Aux Outputs pane (right), select either the Pass Ancillary Data or Regen
Blanking
button to configure all Aux outputs.
With all outputs set to pass or blank ancillary data, you can change individual outputs
to the opposite state.
5 Select any output in the Logical Aux Buses scrolling list (center).
6 Select either the Pass Ancillary Data or Regen Blanking buttons under the Output
Blanking label to set Output Blanking for an individual output.
7 Outputs set to blanking have the word Regen in the upper right of the data pad (all
other states are blank), in the Physical Outputs scrolling list.
Configure Fixed Output Blanking
Configure Fixed Output Blanking for all or individual Fixed outputs to pass or blank ancillary
data in the Eng Setup, Outputs menu.
1 In the Eng Setup, Outputs menu, select either Output or Modular I/O .
2 Select a Fixed output from the Physical Outputs scrolling list or select Fixed in the
Output Type pane to display the Fixed Outputs menu.
3 Result: The Logical Sources/ Fixed Sources scrolling list is displayed (right) along with
other Fixed output parameter functions.
4 In the All Aux Outputs pane (right), select either the Pass Ancillary Data or Regen
Blanking button to configure all Aux outputs.
With all outputs set to pass or blank ancillary data, you can change individual outputs
to the opposite state (see About Passing/Blanking Ancillary Data for Individual
Outputs ).
5 Select any output in the Logical Aux Buses scrolling list (center).
6 Select either the Pass Ancillary Data or Regen Blanking buttons under the Output
Blanking label to set Output Blanking for an individual output.
Outputs set to blanking have the word Regen in the upper right of the data pad (all other
states are blank), in the Physical Outputs scrolling list.