FujiFilm ALPHA 5 RYT-SX, User Manual

Page: 344 / 547

CHAPTER 6 KEYPAD
6-16
Monitor Mode
6
(14) Load inertia ratio (displayed digits: unsigned four digits)
The load inertia ratio recognized by the servo amplifier without relations to parameter PA1_13
(tuning mode selection) is displayed. The value is displayed in a multiple (in 0.1 increments) to the
inertia of the servomotor itself.
The displaying range is from 0.0 to 300.0 times.
(Load inertia ratio) =
(15) DC link voltage (max.) (displayed digits: unsigned three digits)
The DC link voltage (max.) of the servo amplifier at every two seconds is displayed.
The displaying range is from 0 [V] to 500 [V].
(16) DC link voltage (min.) (displayed digits: unsigned three digits)
The DC link voltage (min.) of the servo amplifier at every two seconds is displayed.
The displaying range is from 0 [V] to 500 [V].
(17) VREF input voltage
Only display shown below is indicated as the analog function is not provided.
If the DC link voltage (max.) exceeds 390 [V] during operation, an external braking resistor
is necessary. "HV" (overvoltage) is detected at 420 [V].
"LV" (under-voltage) is detected at 200 [V].
(Load inertia recognized by servo amplifier)
(Inertia of servomotor itself)
SET (1秒以上)
ESC
SET (1秒以上)
ESC
SET (1秒以上)
ESC
SET (1秒以上)
ESC
SET (1 sec. or over)
ESC
SET (1 sec. or over)
ESC
SET (1 sec. or over)
ESC
SET (1 sec. or over)
ESC