FujiFilm ALPHA 5 RYT-SX, User Manual

Page: 147 / 547

CHAPTER 3 OPERATION
Operation Check
3-5
3
3.2.4 Test Operation at Keypad
Using the test operation mode of the keypad, check the motor rotation.
In case of a servomotor equipped with a brake, supply 24 [V] DC to release the brake.
The motor rotates even without a sequence I/O signal.
The relevant parameter settings and default values are shown below.
Parameter No. Name Setting range
Default
value
PA1_37 Acceleration time 1 0.0 [ms] to 99999.9 [ms] 100.0 [ms]
PA1_38 Deceleration time 1 0.0 [ms] to 99999.9 [ms] 100.0 [ms]
PA1_41 Manual feed speed 1 0.01 [r/min] to (max. speed) [r/min] 100.0
Test operation at keypad
Follow the procedure below to check that the output shaft of the servomotor rotates.
[1] Use the [MODE/ESC] key to start the test operation mode [Fn_001].
[2] The servomotor rotates while the key on the keypad is held down.
After checking shaft rotation in the test operation mode, press the [MODE/ESC] key to return until
[Fn_001] is displayed again.
Unless [Fn_001] is displayed again, rotation with the sequence I/O signal is impossible.
Notation of key
In this chapter, keys on the keypad may be simply specified as shown below.
•
[MODE/ESC] key
In the case of [MODE] function: MODE
In the case of [ESC] function: ESC
•
[SET/SHIFT] key
In the case of [SET] function: SET (1 sec. or above)
In the case of [SHIFT] function: SHIFT
Indicates rotation in the
positive direction.
Indicates rotation in the
negative direction.
SET
(1 sec. or over)
∧
∨
ESC
Keeps changing in the offline mode.
SET (1 sec. or over) ESC
SET