FujiFilm ALPHA 5 RYT-SX, User Manual

Page: 286 / 547

CHAPTER 4 PARAMETER
4-90
Input Terminal Function Setting Parameters
4
(2) Connector pin layout (Common to VS and LS types)
The pin layout of each signal is shown in the figure below.
Assign a desired function to signals CONT1 through CONT5.
CONT 6 to 19 are assigned to IQ area.
CN1
35 CA 36 *CA 17 - 18 M5
33 CB 34 *CB 15 - 16 MON1
31 FFA 32 *FFA 13 M5 14 MON2
29 FFB 30 *FFB 11 - 12 PPI
27 FFZ 28 *FFZ 9 M5 10 FZ
25 M5 26 - 7 - 8 -
23
- 24 - 5 OUT1 6 OUT2
21 CONT1 22 CONT2 3 CONT5 4 -
19 COMOUT 20 COMIN 1 CONT3 2 CONT4
PA3_26 to 30 CONT always ON 1 to 5
No. Name Setting range
Default
value
Change
26 CONT always ON 1
27 CONT always ON 2
28 CONT always ON 3
29 CONT always ON 4
30 CONT always ON 5
Specify the number corresponding to
desired function (0 to 76)
0 Power
Specify the CONT input signal that is always enabled after the power is turned on.
The normally open contact signal is always turned on. The normally closed contact signal is always
turned off.
Functions that may not be specified with a normally open signal include alarm reset, deviation clear
and free-run.
Functions that may not be specified with a normally closed signal include forced stop and external
braking resistor overheat. (Functions that can be specified with a normally closed signal are +OT
and -OT.)
For example, to turn forward command [FWD] always on, specify "2," which corresponds to the
forward command, to one of CONT always ON signals 1 to 5.
The signal assigned to CONT input signal can be also assigned to CONT always enabled setting
redundantly.
PA3_36 Deviation clear input form
No. Name Setting range
Default value
Change
36
Deviation clear input
form
0: Edge 1: Level 0 Power
Specify the deviation clear input signal format.
Select 0 (edge) to reset position deviation at the rising edge timing.