FujiFilm ALPHA 5 RYT-SX, User Manual

Page: 269 / 547

CHAPTER 4 PARAMETER
Extended Function Setting Parameters
4-73
4
Control mode
No.
PA2_
Name Default value Power
Position Speed Torque
Record of
reference
value
92 SX extension function *1
）
0
－ ○ ○ ○
*1) The parameter applicable only for VS type.
*2) The parameter applicable only for LS type.
Parameters marked in the table are enabled in the corresponding control mode.
4.5.2 Description of Each Parameter
PA2_54 and 55 Command pulse ratio 1, 2
No. Name Setting range
Default
value
Change
54 Command pulse ratio 1 1.00
55 Command pulse ratio 2
0.01 to 100.00
10.00
Always
This parameter is enabled only for LS type.
Specify the multiplication of the command pulse.
The reference value selected with an input signal ("command pulse ratio 1, 2" assigned to a CONT
signal) is enabled.
PA2_56 Speed limit selection at torque control
No. Name Setting range
Default
value
Change
56
Speed limit selection at
torque control 0: Parameter
1: Speed limit specified in IQ area
0 Power
This parameter is enabled only for VS type.
Select the method of setting limitation on the speed under torque control.
If the setting is 0, the reference value of PA1_26 (maximum rotation speed) is the speed limit.
If the setting is 1, the set value in IQ area becomes the speed limit.