FujiFilm ALPHA 5 RYT-SX, User Manual

Page: 21 / 547

CHAPTER 0 INTRODUCTION
Safety Precautions
0-3
0 ■
Precautions on use
WARNING
Do not touch the inside of the servo amplifier.
There is a risk of electric shock.
Make sure to ground the grounding terminal of the servo amplifier and servomotor.
There is a risk of electric shock.
Before performing wiring or inspection, turn the power off and wait for at least five minutes, and
check that the charge LED is unlit.
There is a risk of electric shock.
Do not give damage or unreasonable stress to cables. Do not place a heavy matter on them or do
not pinch them.
It might cause failure, breakage and electric shock.
Do not touch the rotating part of the servomotor during operation.
It might cause injuries.
CAUTION
Use the servomotor and servo amplifier in a designated set.
It might cause fire and failure.
Never use at places susceptible to water splashes, in corrosive atmosphere, in flammable gas
atmosphere or near flammable matters.
It might cause fire and failure.
As the servo amplifier, servomotor and peripheral devices temperature will become high and
requires careful considerations.
There is a risk of burns.
Do not touch the heat sink of the servo amplifier, braking resistor, servomotor and so on while they
are turned on and for a while after they are turned off due to high temperature.
There is a risk of burns.
If the surface temperature of the servomotor exceeds 70 [°C] during operation of the servomotor of
the final assembly, affix a "hot" caution label.
If a braking resistor is used, take measures to turn the power off upon a fault signal output from the
servo amplifier.
Otherwise the braking resistor may be overheated and cause fire in the event of failure of the
braking transistor.