FujiFilm ALPHA 5 RYT-SX, User Manual

Page: 368 / 547

CHAPTER 6 KEYPAD
6-40
Test Operation Mode
6
<Cause of NG2 indication>
±OT, EMG or external braking resistor overheat is detected in the middle (the free-run signal is
ignored).
The S-ON signal is turned off.
<Cause of NG3 indication>
The motor oscillates even if the auto tuning gain is "4" or less.
(13) Profile operation
Operate the servomotor continuously. Once started, reciprocal operation (depending on parameter
PA1_23) continues until operation is stopped.
Continuous operation is possible even if cables to the host control unit are not connected. Use this
mode to check the effective torque or for other purposes.
Direction of rotation
Operation
pattern name
Travel
distance
Operation
frequency Acceleration
time
Deceleration
time
Rotation
speed
Timer
Go path
Return
path
Profile
operation
PA1_20 Endless PA1_37 PA1_38 PA1_21 PA1_22 PA1_23
*1) If NG indication is shown, remove the cause of the fault and press the [MODE/ESC] key to
restart the offline state.
<Cause of NG1 indication>
±OT, EMG or external braking resistor overheat is detected.
The power is not supplied to the main circuit.
<Cause of NG2 indication>
±OT, EMG or external braking resistor overheat is detected in the middle (the free-run signal is
ignored).
The S-ON signal is turned off.
SET (1秒以上)
ESC
SET
SET
※ 1
オフライン中変化します
SET
(1 sec. or over)
Changes in the offline mode.
During profile operation
Press the MODE key to stop
profile operation.
*1
Offline
(standby state)