FujiFilm ALPHA 5 RYT-SX, User Manual

Page: 135 / 547

CHAPTER 2 WIRING
Description of I/O Signals
2-91
2
The M code is a hexadecimal between 00 and FFH.
The default value of the M code output is FFH (MD0 through MD7 are all turned on).
Parameter setting
To assign MD0 to IQ area (sequence output terminal), specify the corresponding value ("60") to
the output terminal function setting parameter. M code area is already provided in IQ area.
Relevant description
(1) M code setting range
Enter the M code in a binary between 00h and FFh.
(2) Output at startup(during positioning)/output at completion(after completion)
You can select the M code output timing between during execution of positioning data (output at
start) and after execution of positioning data (output at completion).
Output at startup (during positioning)
The signal is issued since the start of the positioning motion to the end. After the positioning
motion is finished, the signal is turned off.
Output at completion (after completion)
The signal is output at positioning completion and is hold.
Rotation
speed
Ready for
servo-on
Simultaneous output of M code
Time
ON
ON OFF
Start
positioning
AD7 to AD0 35 99
In-position
(level)
ON OFF ON
M code
Timer
(positioning data)
FF FF 20
* Positioning data is executed while the timer time is counted.
* The default value of the M code is FF.
M code 20