8
8
8-121
8-121
Service Mode > COPIER > OPTION > IMG-TR
Service Mode > COPIER > OPTION > IMG-TR
COPIER > OPTION > IMG-FIX
FXS-TM11
Image formation start temp: recycled ppr
Lv.1 Details
To set the offset of image formation start temperature for recycled
paper (64 to 82 g/m2).
As the value is incremented by 1, the control temperature is increased
by 5 deg C.
Use case
- When a fixing failure occurs at the leading edge of paper
- When uneven gloss occurs in the area that is 76 mm from the
leading edge
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range
-2 to 2
Unit
5 deg C
Default value
0
T-8-40
■
IMG-TR
COPIER > OPTION > IMG-TR
ITB-TYPE
Setting of ITB type
Lv.2 Details
"To set the type of the ITB to be used.
Be sure to execute Auto Adjust Gradation/Auto Correct Color Mismatch
after replacement of the ITB Unit."
Use case
When replacing the ITB Unit with a different type of the unit
Adj/set/operate method Enter the setting value, and then press OK key.
Caution
"- Even the ITB is replaced with a new one, ghost will not be alleviated
unless the setting of ITB-TYPE is set to 1.
- When setting ITB-TYPE to 1 with an old ITB, ghost due to re-transfer
gets worse.
- The value is maintained even if the DCON cleared."
Display/adj/set range
"0 to 2
0: Old type
1: New type
2: Not used"
Default value
The value differs according to the product configuration.
Related UI menu
"Settings/Registration> Adjustment/Maintenance> Auto Adjust
Gradation
Settings/Registration> Adjustment/Maintenance> Auto Correct Color
Mismatch"
Supplement/memo
"- ITB identification method
New type: Color of the handle at rear side is gray, and color of the
barcode label is yellow."
TRDATENV
Pry trn tgt crrnt crrct ev setting: R&D
Lv.1 Details
To set the environment to execute the primary transfer target current
correction after a specified number of sheets is fed.
Check the use environment from COPIER> DISPLAY> MISC> ENV-
TR.
Set the number of sheets to be fed for correction by TRDAYCNT and
set the correction value by TRDAYTGT.
Use case
When density varies at the time of making a large number of outputs
Adj/set/operate method Enter the setting value, and then press OK key.
Caution
Do not use this at the normal service.
Display/adj/set range
0 to 4
0: OFF, 1: Low humidity environment, 2: Normal humidity environment,
3: High humidity environment, 4: All environments
Default value
0
Related service mode COPIER> DISPLAY> MISC> ENV-TR
COPIER> OPTION> IMG-TR> TRDAYCNT, TRDAYTGT
