Canon CXDI-31, Service Manual

Page: 174 / 209

3. CXDI-31 Imaging Unit
- 18 -
(1) Follow the steps (1) to (5) in “3.2.2.1 Replacing the new sensor cable (BG7-3055) to
remove the rear cover and the cable.
(2)
Insert the cable into the groove of sensor unit cover.
(3) Secure the cable with the cable clamp (BA4-2364), two screws (XA1-1260-606) and two
washers (XD1-1102-625).
[Fig.3]
[Fig.4]
(4) At reassembly, reverse the steps (1) to (5) in “3.2.2.1 Replacing the new sensor cable
(BG7-3055).
Note:
The exterior cover is made of a magnesium alloy. Remember that tightening the screws
with excessive force could strip the nut.
Note:
When attaching the rear cover, be careful not to pinch the power cables and the others
with the covers. Refer to “3.1.3 Notes on installing the rear cover in “3.1 Notes”.
Cable clamp
Insert the cable into the
groove of the sensor cover
Screws and washers (x2)