Canon CXDI-31, Service Manual

Page: 91 / 209

2 Installation Manual
- 65 -
•
Kodak DryView 8700+9440
Default Parameters
-A 320 -T NO -M CUBIC –S “LUT=m, n”-m (on-site adjustment)
(entered in param member)
78 (entered in pixelPitch member)
4096 (entered in W member)
5220 (entered in H member)
The model 8800 has a rotation function but we understand that Imation has not publicly
acknowledged the use of this function.
Significance
•
Trimming OFF
•
Cubic spline interpolation
•
Maximum density: 3.20
•
LUT = m, n is designated as the Config Info but m and n are adjusted on-site by the
Kodak service engineer. Basically, adjustment is performed to achieve a linear output.
•
The Kodak service engineer is responsible for setting the smoothing type on-site since it
can be changed with each printer.
•
The rest is done by the printer itself.
•
Kodak Dry View 8500+
Default
Parameters
-A 310 -T NO -M CUBIC -m ? -S LUT=0?, 2? (?: Site Dependent)
(entered in param member)
78 (entered in pixelPitch member)
14x17
3388 (entered in W member)
4277 (entered in H member)
Significance
•
Trimming OFF
•
Cubic spline interpolation
•
Smoothing must be adjusted at the user’s site.
•
Maximum density: 3.10
•
-S LUT = m, n is designated as the Config Info but m and n are adjusted on-site by the
Kodak service engineer. Basically, adjustment is performed to achieve a linear output.