Canon CXDI-31, Service Manual

Page: 57 / 209

2 Installation Manual
- 31 -
4.3.5. Checking the Sensor Serial No.
(1) Purpose
1) When the A/D boot loader is installed, the sensor serial number (image file name)
written in the flash ROM of the A/D board can be erased. Therefore, the sensor serial
number must be checked.
2) Also, if the sensor serial number stored in the flash ROM of the A/D board differs from
the image data file name stored in the hard drive of the control PC during installation,
the connected sensor can not be detected after the CXDI application is launched. In that
case an error message appears.
(2) Notes
1) This checking procedure should always be performed in the following cases.
1 When the A/D boot loader has been rewritten during installation.
2 When the A/D board has been replaced.
3 When the sensor in the imaging unit has been replaced.
2) This checking procedure cannot be performed with only the control PC.
Connect the imaging units and other equipment, and then start up in the normal imaging
status.
(3) Procedure
1) Connect the keyboard and mouse to the control PC.
2) Use the capture board interface cable to connect P1 on the capture board to PORT1
(COM3) on the serial board.
* For more information on connections, see “Hyper Terminal Settings”.
3) Start up the CXDI system.
* Start up the CXDI application. If the CXDI application is not started up, you can
not go to the checking steps.
4) When the normal imaging screen is displayed on the operation unit, start up Hyper
Terminal for settings.
* For the settings, see “Hyper Terminal Settings”.
5) After making the HyperTerminal settings, press the [Enter] key on the keyboard.
* In the following steps, always press the [Enter] key after making the keyboard
input.