Cambium Networks PTP 820 Series, User Manual

Page: 545 / 1149

Chapter 9: TDM Services and Interfaces Configuring TDM Pseudowire Services
phn-3965_006v002
Page 9-37
Figure 313 Pseudowire Service Creation – Protecting Interface Selection Page
o
If you selected 1+1 Dual Homing Network Edge in the Protection field, click Next . The Working EC ID
Selection page opens. Skip steps 11 through 13 and proceed to Step 14.
Figure 314 Pseudowire Service Creation – Working EC ID Selection Page
11 In the Slot/Group/Port field, In the Slot/Group/Port field, select a radio interface, Radio Protection group,
Multi-Carrier ABC group, or cascading interface to serve as the interface for the protecting path.
Note
Some interfaces may not appear in the Slot/Group/Port field. Refer to Limitations on Available
Endpoints for the possible reasons an interface will not appear. If there are no available interfaces, a
message appears that no endpoint can be selected.
12 In the VLAN Type field, select the VLAN Type for the protecting path endpoint. The VLAN Type determines
which frames enter the service via this endpoint, based on the frame's VLAN tagging. Options are:
o
S-TAG – A single S- VLAN is classified to the service point.
o
C-TAG – - A single C- VLAN is classified to the service point.
13 In the S-VLAN or C-VLAN field, select the VLAN you want to classify to the endpoint (1-4090).