Chapter 9: TDM Services and Interfaces
Configuring Advanced Pseudowire Parameters
phn-3965_006v002
Page 9-44
Configuring Advanced Pseudowire Parameters
To configure pseudowire services, it is recommended to use the TDM Pseudowire Services page, which provides a
step-by-step workflow based on pre-configured pseudowire settings. See
Configuring TDM Pseudowire Services
To manually configure the pseudowire parameters and services, follow the instructions in this section to configure
the parameters located in the
TDM > TDM PseudoWire > Advanced
section of the Web EMS.
This section includes:
•
Configuring Pseudowire Card Parameters
•
Configuring OEM for Pseudowire Services
•
Configuring Pseudowire Tunnels and Tunnel Groups
•
Configuring Pseudowire Profiles
•
Configuring Pseudowire TDM Services Manually
Note
The DS0 Bundles page is reserved for future use.
Configuring Pseudowire Card Parameters
To configure the pseudowire parameters of the E1/DS1 interface:
1
Select
TDM > TDM PseudoWire > Advanced > Configuration
. The PseudoWire Card Configuration page
opens.
Figure 322
PseudoWire Card Configuration Page
2
Select the E1/DS1 interface and click
Edit
. The PseudoWire Card Configuration
–
Edit page opens.
Figure 323
PseudoWire Card Configuration
–
Edit Page
Summary of Contents for PTP 820 Series
