Cambium Networks PTP 820 Series, User Manual, Page: 843 / 1149

Chapter 18: Ethernet Services and Interfaces (CLI) Configuring Ethernet Services (CLI)
phn-3965_006v002
Page 18-24
Table 193 S-VLAN CoS Preservation CLI Parameters
Parameter Input Type Permitted Values Description
sp-id Number 1-32 for P2P and
MP services.
1-30 for MNG
services. The Service Point ID.
s-vlan cos
preservation
mode Variable enable
disable Select
enable
or
disable
to determine whether
the original S-VLAN CoS value is preserved or
restored for frames egressing the service point.
enable – the S-VLAN CoS value of frames
egressing the service point is the same as the value
when the frame entered the service.
disable
– the S-VLAN CoS value of frames
egressing the service point is set at whatever value
might have been re-assigned by the interface,
service point, or service, or whatever value results
from marking (see
Configuring Marking (CLI) ).
The following command enables S-VLAN CoS preservation for Service Point 1 on Service 37:
service[37]>sp svlan-cos-preservation-mode set spid 1 mode enable
The following command disables S-VLAN CoS preservation for Service Point 1 on Service 37:
service[37]>sp svlan-cos-preservation-mode set spid 1 mode disable
Configuring Service Bundles (CLI)
You can use service bundles to personalize common sets of egress queue attributes that can be applied to multiple
service points. In this version only one service bundle is supported.
To assign a service point to a service bundle, go to service view for the service and enter the following command:
service[SID]>sp egress-service-bundle set spid 1 service-bundle-id
<service-bundle-id>