Cambium Networks PTP 820 Series, User Manual, Page: 889 / 1149

Chapter 19: Quality of Service (QoS) (CLI) Configuring Policers (Rate Metering) (CLI)
phn-3965_006v002
Page 19-22
Displaying Rate Meter Statistics for an Interface (CLI)
For the rate meter (policer) at the logical interface level, you can display the following statistics counters:
•
Green Frames
•
Green Bytes
•
Yellow Frames
•
Yellow Bytes
•
Red Frames
•
Red Bytes
Note
Rate meter (policer) counters are displayed in granularity of 64 bits.
The following commands display rate meter counters for the available frame types and Ethertypes:
eth type eth [x/x]>rate-meter unicast show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter multicast show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter broadcast show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter ethertype1 show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter ethertype2 show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter ethertype3 show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
Table 233 Displaying Rate Meter Statistics CLI Parameters
Parameter Input Type Permitted Values Description
clear-on-read Boolean yes
no
If you enter yes, the statistics are cleared
once you display them.
layer 1 Boolean yes
no
yes
– Statistics are represented as Layer 1
statistics, including preamble and IFG.
no – Statistics are represented as Layer 2
statistics.
The following commands display rate meter counters for GbE 1, for each of the available frame types and
Ethertypes. These commands clear the counters after displaying them.
eth type eth [1/1]>rate-meter unicast show statistics clear-on-read yes
layer-1 no