Cambium Networks PTP 820 Series, User Manual

Page: 827 / 1149

Chapter 18: Ethernet Services and Interfaces (CLI) Configuring Ethernet Services (CLI)
phn-3965_006v002
Page 18-8
Table 179 Ethernet Service Default CoS CLI Parameters
Parameter Input Type Permitted Values Description
cos Number 0 – 7 This value is assigned to frames at the service level
if
cos-mode
is set to
default-cos
. Otherwise,
this value is not used, and frames retain whatever
CoS value they were assigned at the service point
or logical interface level.
The following commands configure Service 10 to assign a CoS value of 7 to frames traversing the service:
service[10]>service cos-mode set cos-mode default-cos
service[10]>service default-cos set cos 7
The following command configures Service 10 to preserve the CoS decision made at the interface or service point
level for frames traveling through the service:
service[10]>service cos-mode set cos-mode preserve-sp-cos-decision
Configuring a Service’s EVC ID and Description (CLI)
To add or change the EVC ID of a service, go to service view for the service and enter the following command:
service[SID]>service evcid set <evcid>
To display a service’s EVC ID, go to service view for the service and enter the following command:
service[SID]>service evcid show
To add or change the EVC description of a service, go to service view for the service and enter the following
command:
service[SID]>service description set <evc description>
To display a service’s EVC description, go to service view for the service and enter the following comm and:
service[SID]>service description show
Table 180 Ethernet Service EVC CLI Parameters
Parameter Input Type Permitted Values Description
evcid Text String Up to 20
characters. Defines an Ethernet Virtual Connection (EVC) ID.
This parameter does not affect the network
element’s behavior, but is used by the NMS for
topology management.
To display a service’s EVC ID, go to service view for the service and enter the following command:
service[SID]>service evcid show
To add or change the EVC description of a service, go to service view for the service and enter the following
command:
service[SID]>service description set <evc description>