Cambium Networks PTP 820 Series, User Manual, Page: 1065 / 1149

Chapter 24: Alarm Management and Troubleshooting (CLI) Performing Diagnostics (CLI)
phn-3965_006v002
Page 24-29
To stop a loopback that is already in progress, enter the following command in root view:
root> ethernet soam loopback stop meg-id <meg-id> mep-id <mep-id>
Table 328 Loopback CLI Parameters
Parameter Input Type Permitted Values Description
meg-id Number 1-4294967295 The MEG ID of the MEG on which the loopback is
being configured or run.
mep-id Number 1-8191 The MEP ID of the MEP on which the loopback is
being configured or run.
interval Number 0-60000 The interval (in ms) between each loopback
message. Note that the granularity for this
parameter is 100 ms. If you enter a number that
is not in multiples of 100, the value will be
rounded off to the next higher multiple of 100.
Also, the lowest interval is 1000 ms (1 second). If
you enter a smaller value, it will be rounded up
to 1000 ms.
size Number 64-1518 The frame size for the loopback messages. Note
that for tagged frames, the frame size will be
slightly larger than the selected frame size.
pattern Variable zeroPattern
onesPatter The type of data pattern to be sent in an OAM
PDU Data TLV.
priority Number 0-7 The priority bit for tagged frames.
drop Boolean true
false true – Frame dropping is enabled.
false – Frame dropping is disabled.
dest-mac-addr Six groups of
two
hexadecimal
digits
The MAC address of the interface to which you
want to send the loopback. If you are not sure
what the interface’s MAC address is, you can get
it from the Interface Manager by entering the
platform if-manager show interfaces
command in root view.