Cambium Networks PTP 820 Series, User Manual, Page: 396 / 1149

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Interfaces
phn-3965_006v002
Page 6-25
Figure 200 Physical Interfaces - Edit Page
3. Optionally, in the Description field, enter a description of the interface.
4. In the Media type field, select the physical interface layer 1 media type. Options are:
o
Auto-Type – NA.
o
RJ45 – An electrical (RJ-45) Ethernet interface.
o
SFP – An optical (SFP) Ethernet interface.
o
Radio – A radio interface.
5. In the Auto negotiation field, select On to enable or Off to disable Auto-Negotiation. When the Media-Type
is Radio , Auto Negotiation is always Off .
6. In the Speed field, select the maximum speed of the interface, in Mbps. Options are:
o
Ethernet RJ-45 interfaces – 100 and 1000 .
o
Ethernet SFP interfaces – Only 1000 is supported.
o
Radio interfaces – The parameter is read-only and set by the system to 1000 .
7. In the Duplex field, select the interface's duplex setting ( Full-Duplex or Half-Duplex ). Only Full-Duplex is
available in this release.
8. Click Apply , then Close .
Table 67 describes the status parameters that appear in the Physical Interfaces page.
Table 67 Physical Interface Status Parameters