Cambium Networks PTP 820 Series, User Manual, Page: 204 / 1149

Chapter 3: Configuration Guide Configuring a Link Using the Quick Configuration Wizard
phn-3965_006v002
Page 3-46
11 In the TX Level (dBm) field, enter the desired TX signal level (TSL). The range of values depends on the
frequency and RFU type.
12 To mute the TX output of the RFU, select On in the TX Mute field. To unmute the TX output of the RFU,
select Off .
Note
The frequency settings are applied to both the Active and the Standby radios. However, the TX Level
and Mute settings are applied only to the Active radio. You must manually set the TX Level and
unmute the Standby radio in order for 1+1 protection to function. See
Configuring the Radio
Parameters .
13 Click Next . Page 4 of the 1+1 Multi Carrier ABC HSB-SD Quick Configuration wizard opens.
Figure 73 1+1 Multi Carrier ABC HSB-SD Quick Configuration Wizard – Page 4
14 In the Script ID field, select the MRMC script you want to assign to the radios. For a full explanation of
choosing an MRMC script, see Entering Radio View (CLI)
To view and configure radio parameters, you must first enter the radio’s view level in the CLI.
Use the following command to enter a rad io’s view level:
root> radio slot <slot> port <port>
The following command enters radio view for fixed radio interface 1:
root> radio slot 1 port 1
The following prompt appears:
radio[1/1]>
The following command enters radio view for fixed radio interface 2:
root> radio slot 1 port 2
The following prompt appears:
radio[1/2]>
The following command enters radio view for an RMC in expansion slot 3: