Cambium Networks PTP 820 Series, User Manual

Page: 797 / 1149

Chapter 17: Radio Configuration (CLI) Configuring ATPC and Override Timer (CLI)
phn-3965_006v002
Page 17-8
radio[x/x]>atpc override show admin
To display the ATPC override timeout, enter the following command in radio view:
radio[x/x]>atpc show override timeout
To set the TX power to be used when the unit is in an ATPC override state, enter the following command in radio
view:
radio[x/x]>atpc set override-tx-level <override-tx-level>
To display the ATPC override TX power, enter the following command in radio view:
radio[x/x]>atpc show override tx-level
To display the current ATPC override state, enter the following command in radio view:
radio[x/x]>atpc show override
Possible values are:
•
Normal – ATPC override is enabled, and there is no override.
•
Disabled – ATPC override is not enabled.
•
Override – ATPC override has been activated.
To cancel ATPC override, enter the following command in radio view:
radio[x/x]>atpc set override-cancel
Table 160 Radio ATPC CLI Parameters
Parameter Input Type Permitted Values Description
admin Variable enable
disable
Enables or disables ATPC mode.
rx-level Number -70 - -30 The RX reference level for the ATPC
mechanism.
timeout Number 0-1800 The amount of time, in seconds, the
timer counts from the moment the
radio reaches its maximum configured
TX power until ATPC override goes into
effect.
override
admin Variable enable
disable
Enables or disables ATPC override.
override-tx-
level Number -50 - 50 The TX power, in dBm, to be used
when the unit is in an ATPC override
state. The range of values depends on
the frequency, MRMC script, and RFU
type.
The following commands enable ATPC mode for radio interface 1 and set the RX reference level to -55:
radio[2/1]>atpc set admin enable