Cambium Networks PTP 820 Series, User Manual, Page: 687 / 1149

Chapter 12: Alarm Management and Troubleshooting Performing Diagnostics
phn-3965_006v002
Page 12-37
Displaying Remote MEPs
To display a list of remote MEPs (RMEPs) and their parameters:
1. Select Ethernet > Protocols > SOAM > MEP . The SOAM MEP page opens ( Figure 417 ).
2. Select a MEP and click RMEP List . The SOAM MEP DB table is displayed.
Figure 422 SOAM MEP DB Table
Table 126 lists and describes the parameters displayed in the SOAM MEP DB table. To return to the SOAM MEP
page, click Back to MEP .
Table 126 SOAM MEP DB Table Parameters
Parameter Definition
RMEP ID The remote MEP ID.
RMEP Operational State The operational state of the remote MEP.
RMEP Last rx CCM MAC
Address
The MAC Address of the interface on which the remote MEP is located.
RMEP Last CCM OK or Fail
Timestamp The timestamp marked by the remote MEP indicated the most recent
CCM OK or failure it recorded. If none, this field indicates the amount of
time since SOAM was activated.
RMEP Last rx CCM RDI
Indication Displays the state of the RDI (Remote Defect Indicator)bit in the most
recent CCM received by the remote MEP:
•
True – RDI was received in the last CCM.
•
False – No RDI was received in the last CCM.
RMEP Last rx CCM Port
Status TLV The Port Status TLV in the most recent CCM received from the remote
MEP. Reserved for future use.
RMEP Last rx CCM
Interface Status TLV Displays the operational status of the interface on which the remote MEP
has been defined.