Cambium Networks PTP 820 Series, User Manual, Page: 974 / 1149

Chapter 21: TDM Services and Interfaces (CLI) Configuring TDM Pseudowire Services (CLI)
phn-3965_006v002
Page 21-13
Table 281 Pseudowire Profile CLI Parameters
Parameter Input Type Permitted Values Description
id Number 1-64 A unique ID that identifies the profile.
payload-size Number 1-64 The number of times E1 should be
sampled for each Ethernet packet.
jitter-buffer-
depth Number 1-32 The desired jitter buffer depth (in
milliseconds). This is used to enable the
network to accommodate PSN-specific
packet delay variation. The jitter buffer
can be increased if the network
experiences a higher-than-normal level
of jitter.
payload-
suppression Variable enable
disable Enables or disables payload suppression.
When enabled, the payload is
suppressed upon incoming TDM failure.
The following commands add TDM profile 5, with a payload size of 2, jitter buffer depth of 4 milliseconds, and
payload suppression disabled:
pwe3> pwe3 pw-profile add id 5
pwe3> pwe3 pw-profile basic-params modify id 5 payload-size 2 jitter-
buffer-depth 4 payload-suppression disable
To verify the details of the profile you just created, enter the following command:
pwe3> pwe3 pw-profile show id 5
Configuring Ethernet Services for TDM Traffic (CLI)
You can configure traffic services for TDM traffic using the same commands and parameters used for Ethernet
services. For instructions, refer to
Ethernet Services Overview (CLI) .
The following commands add a multipoint service with an EVC ID of PW-Slot12_EVC-70. This service has the
following service points:
•
A service point on a 1+1 HSB group (rp3), with an s-tag interface type and VLAN 4070 classified to the service
point.
•
A service point on the E1/DS1 interface, port 1, with a dot1q interface type and VLAN 4070 classified to the
service point.