Cambium Networks PTP 820 Series, User Manual, Page: 935 / 1149

Chapter 20: Ethernet Protocols (CLI) Configuring G.8032 (CLI)
phn-3965_006v002
Page 20-12
root> ethernet g8032 show-erpi-sp-state erpi-id 1 SP east
The following is an example of this command's output.
Table 264 G.8032 Service Point Display Command Output Parameters
Parameter Description
ERPI ID A unique ID that identifies the ERPI.
SP Index Identifies the service point in the ERPI.
SP ID The Service Point ID.
Active State Indicates whether or not the service point is active for traffic forwarding.
R-APS Channel
Forwarding State Indicates whether the service point is forwarding R-APS messages.
Data Forwarding State Indicates whether the service point is in unblocked (forwarding) state.
RPL Link Blocked State Only relevant if the ERPI to which the service point belongs is the RPL
owner. Indicates whether the service point is in blocked state.
Defect State Indicates whether the service point is in Signal Fail (SF) or Signal Defect
(SD) state.
Note: Support for Signal Defect state is planned for future release.
TX R-APS Frames The number of R-APS frames that have been transmitted via the service
point.
TX R-APS SF The number of R-APS Signal Fail (SF) frames that have been transmitted
via the service point.
TX R-APS NR The number of R-APS No Request (NR) frames that have been transmitted
via the service point.
TX R-APS RB The number of R-APS RPL Blocked (RB) frames that have been
transmitted via the service point.
TX R-APS SD The number of R-APS Signal Degrade (SD) frames that have been
transmitted via the service point.
TX R-APS FS The number of R-APS Forced Switch (FS) frames that have been
transmitted via the service point.
TX R-APS MS The number of R-APS Manual Switch (MS) frames that have been
transmitted via the service point.
TX R-APS Event Reserved for future use.