ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 803 / 1168

Chapter 29 port Commands
Management Switch Card User’s Guide
803
This command displays downlink interfaces created manually. It does not show forwarding
information learned by snooping DHCP packets.
An example is shown next.
The output values correspond to the input values of other IP bridge downlink interface commands.
29.22 IP Bridge Routing Table Commands
Use these commands to set up and maintain the routing table for each domain.
Each domain has its own routing table. Each routing table contains entries that, based on the
destination IP address, control where the system forwards packets (for upstream and downstream
traffic). The system automatically creates routing table entries for each downlink interface and for
each edge router in the domain. You can create additional entries by specifying the edge router to
which the system should forward traffic for a particular destination IP address or IP subnet.
29.22.1 port ipbpvc route delete Command
Syntax:
port ipbpvc route delete < domain-name > < ip/mask > < nexthop >
where
This command deletes the specified entry from the routing table of the specified domain. You can
only remove entries that were added manually.
ras> port ipbpvc interface show 402
ip/mask vid slot port vpi vci
------------------ ---- ---- ---- --- ----
192.168.3.0/24 402 - - - -
< domain-name > =
The name of the domain.
< ip/mask > =
IP address, in dotted decimal notation and number of bits <0..32> in the subnet
mask.
< nexthop > =
IP address, in dotted decimal notation.