ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 297 / 1168

Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
297
9.28.1 ENET Port Setup Line Card Screen
Click Port > ENET in the navigation panel to open the ENET Port Setup screen. Click the slot
number of an active Ethernet line card to open the following screen. Use this screen to configure
settings for individual Ethernet ports and copy settings between ports.
Cancel Click Cancel to begin configuring the screen again.
Copy Do the following to copy settings from one subscriber port to another subscriber port or
ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the number
of the port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 192
Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this screen.
Click Cancel to close the screen without saving changes.
ID This column lists the slot numbers of the line cards. Click the ID number of an active line
card to go to a screen where you can copy port settings to another port.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See Section 38.7 on
page 1111 for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was
started.
Firmware This field displays the current firmware version installed on the line card.
Table 135
ENET Port Setup (continued)
LABEL DESCRIPTION