ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 740 / 1168

Chapter 28 multicast Commands
Management Switch Card User’s Guide
740
28.2.3 multicast bandwidth set Command
Syntax:
multicast bandwidth set < index > < start-mcast-ip > < end-mcast-ip > < bandwidth >
where
This command configures bandwidth allocation for the multicast channel(s). For multicast
channel(s) for which you have not configured bandwidth settings, the default multicast bandwidth
setting applies (refer to
Section 28.2.1 on page 739 ).
The following example sets the bandwidth allowed for the specified multicast channels to 1000
Kbps.
28.3 multicast bandwidth port Commands
Use these commands to configure multicast bandwidth limitation on specified ports.
28.3.1 multicast bandwidth port disable Command
Syntax:
multicast bandwidth port disable < slot-port >
This command deactivates multicast bandwidth settings of the specified port.
28.3.2 multicast bandwidth port enable Command
Syntax:
multicast bandwidth port enable < slot-port >
This command activates multicast bandwidth setting on the specified port.
28.3.3 multicast bandwidth port set Command
Syntax:
multicast bandwidth port set < slot-port > <bandwidth>
< index >
=
A unique number for this setting.
< start-mcast-ip >
=
The start of the multicast address range.
< end-mcast-ip >
=
The end of the multicast address range. For one multicast address, enter
the start multicast address again.
< bandwidth >
= Allowed bandwidth between 1 and 1000 000 kbps (kilo bits per second).
ras> multi band set 1 230.230.1.1 230.230.1.10 1000