ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 734 / 1168

Chapter 27 lcman Commands
Management Switch Card User’s Guide
734
The following table describes labels in the example.
Table 361
lcman show Command: Detailed Information
LABEL DESCRIPTION
slot This is the slot number followed by the model of card that is installed or was last
installed in the slot.
uptime This is how long the card has been active.
f/w version This is the release of firmware that the card is using.
status The following columns display a “V” if an alarm has been detected. “-” displays if no
related alarm has been detected.
hardware sensor This displays the condition of the card’s hardware monitor sensor.
temperature This displays whether or not the card’s measured temperature is within the configured
operating thresholds.
voltage This displays whether or not the card’s measured current is within the configured
operating thresholds.
module exist This displays whether or not the card is installed.
module status This displays whether or not the installed card is up (active).
hardware version This is the version of the card’s physical hardware.
hardware serial
number This is the card’s individual identification number assigned at the factory.
firmware version This is the release of firmware that the card is using.
DSL driver version This is the driver version that a DSL line card’s DSL chip is using.
DSL modem version This is the release of modem code that a DSL line card is using.
current voltage level These are the voltages (in volts) measured at the card’s sensors. An “*” indicates the
voltage is outside of the configured thresholds.
current temperature These are the temperatures (in degrees Celsius) measured at the card’s sensors. An
“*” indicates the temperature is outside of the configured thresholds.