ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 741 / 1168

Chapter 28 multicast Commands
Management Switch Card User’s Guide
741
This command sets the bandwidth allowed for multicast traffic on the specified port(s).
This following example sets the multicast bandwidth limit to 1000 kbps on port 1 on the line card in
slot 3.
After using this command, if the device receives a join report and the total multicast traffic at that
moment is over 1000 kbps, the device ignores the join report.
28.3.4 multicast bandwidth port show Command
Syntax:
multicast bandwidth port show < slot | slot-port >
This command displays the multicast bandwidth setting on the specified port. The following
example shows the multicast bandwidth setting for port 1 on the line card in slot 2.
28.4 multicast Group MAC Address Commands
Use these commands to allow incoming frames based on multicast MAC address(es) that you
specify. Use this feature to pass allowed layer 2 multicast packets through the IES.
28.4.1 multicast groupmacaddr del Command
Syntax:
multicast groupmacaddr del < vid > < group-mac-addr >
where
This command removes a static multicast group entry by MAC address. The following example
removes multicast MAC address 01:01:5E:00:00:05 from VID 2.
ras> multicast bandwidth port set 3-1 1000
ras> multicast bandwidth port show 2-1
port enable bandwidth
------ ------ -----------
2- 1 V 1024
< group-mac-addr >
=
The static multicast MAC address.
ras> multicast groupmacaddr del 2 01:01:5E:00:00:05 9-2 fix