ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 530 / 1168

Chapter 13 Switch Screens
Management Switch Card User’s Guide
530
13.12.3 MSTP Configuration Example
This section shows you how to configure MSTP settings for the network example shown. In this
network example, there are two VLANs on two spanning tree instances.
Figure 363
MSTP Network Example 2
1
Log into the Web Configurator and access the MSTP-Bridge screen.
2
Specify a descriptive name in the Config Name field for the MSTP region.
3
Enter a number in the Revision Level field.
4
To create VLAN-to-MSTI mapping, set the MSTID , Start VID and End VID fields and click Apply .
For this example, map VLAN 1 to MSTID 1 and VLAN 2 to MSTID 2.
P2P Set a point-to-point link between ports to increase the speed of convergence by allowing the
network to determine the designated port faster. The port must be connected directly to another
switch port.
Select Enable to activate this feature on a full-duplex port that is connected directly to another
switch port.
Select Disable to deactivate this feature on the port that is in half-duplex mode.
Select Auto to have the system automatically determine if the port is full-duplex or half-duplex.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to start configuring this screen again.
Table 280
MSTP: Port (continued)
LABEL DESCRIPTION