ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 595 / 1168

Chapter 15 VLAN Screens
Management Switch Card User’s Guide
595
15.7 VLAN Port Setting Screen
Click VLAN > Port Setting in the navigation panel to display the screen shown next. You can
select a DSL line card to view the VLAN settings on its ports.
Registration Select Normal for the port to dynamically join this VLAN group using GVRP.
Select Fix for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
You cannot change a port from the fixed state to another state if the port’s PVID is set to
this VLAN. The VLAN must have at least one port set to the fixed status if the VLAN is the
CPU (management) VLAN.
Tag Select this check box if you want to tag all frames transmitted though a port with this VLAN
group ID.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
New Click New to start configuring the screen again.
Cancel Click Cancel to start configuring the screen again.
Show VID From Type a range of VLAN IDs that you want to view and click Apply to display them in the table
below.
Index This field displays the number of the VLAN entry in this list.
Name This field displays the descriptive name for this VLAN group.
VID This field displays the ID number of the VLAN group. Click the number to edit the VLAN
settings.
Enable This field indicates whether the VLAN settings are enabled ( V ) or disabled ( - ).
ENET Ports This column displays the VLAN tagging settings of the MSC’ Gigabit Ethernet interfaces.
ENET port 1 and 2 are subtending ports 1 and 2.
ENET port 3 and 4 are uplink ports 1 and 2.
ENET ports 5~8 do not apply (and nothing displays).
T displays if the system is to tag all frames transmitted though the port with this VLAN
group ID.
U displays if the system is not to tag all frames transmitted though the port with this VLAN
group ID.
An X indicates that the port is forbidden (blocked) from joining the static multicast group.
An - indicates that the port is a normal member and can join the VLAN dynamically.
Page X of X This identifies which page of information is displayed and the total number of pages of
information.
Previous/Next
Page Click one of these buttons to show the preceding/following screen if the information cannot
be displayed in one screen.
Modify Select a VLAN’s Select radio button and click Modify to edit the VLAN.
Delete Select a VLAN’s Select radio button and click Delete to remove the VLAN. You cannot
delete the CPU (management) VLAN.
Table 321
VLAN Setup (continued)
LABEL DESCRIPTION