ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 1028 / 1168

Chapter 33 switch Commands
Management Switch Card User’s Guide
1028
This command sets the port speed and duplex of a 1000BaseT uplink port(s).
The following example sets the speed of the uplink 1 Gigabit Ethernet interface to 1000 Mbps and
the duplex to full.
33.15 switch port vlantrunk Commands
Use these commands to turn VLAN trunking on or off for the Gigabit Ethernet interfaces.
33.15.1 switch port vlantrunk enable Command
Syntax:
switch port vlantrunk enable < giga-port >
where
This command sets a Gigabit Ethernet interface(s) to use VLAN trunking in order to accept frames
with any VID.
The following example sets the subtending 1Gigabit Ethernet interface to use VLAN trunking.
33.15.2 switch port vlantrunk disable Command
Syntax:
switch port vlantrunk disable < giga-port >
where
This command sets a Gigabit Ethernet interface(s) to not use VLAN trunking so the port only
accepts frames with registered VIDs.
The following example sets the subtending 1Gigabit Ethernet interface to not use VLAN trunking.
ras> switch port speed up1 1000F
< giga-port >
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports. Use
sub1|sub2|up1|up2|all i
f trunking is not enabled. Use
tsub|tup|all
if trunking is enabled.
ras> switch port vlantrunk enable sub1
< giga-port >
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports. Use
sub1|sub2|up1|up2|all i
f trunking is not enabled. Use
tsub|tup|all
if trunking is enabled.
ras> switch port vlantrunk disable sub1