ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 243 / 1168

Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
243
9.8.10.2 XVLAN Port Setup Line Card Screen
Click the slot number of an active VDSL line card in the Xvlan Setup screen to open the following
screen. Use this screen to delete XVLAN settings from individual VDSL ports.
Figure 151
VDSL Port Setup: Xvlan Setup: Slot
Svid This is the service provider VLAN ID used on the service provider’s network.
Cvid-s This applies to the VLC13XXG cards. This is the translated customer VLAN ID used on the
service provider’s network.
Select Select an entry’s radio button and then click Modify to be able to edit it or click Delete to
remove it.
Cvid Specify the original customer VLAN ID (from 1 to 4094) of the subscriber traffic to which this
XVLAN entry is too apply.
Svid Specify the service provider VLAN ID (from 1 to 4094) to use for the subscriber traffic when
forwarding it to the service provider’s network.
Cvid-s This applies to the VLC13XXG cards. Specify the customer VLAN ID (from 1 to 4094) to use for
the subscriber traffic when forwarding it to the service provider’s network.
Enter 0 to not use a customer VLAN ID for the subscriber traffic when forwarding it to the
service provider’s network.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to begin configuring the screen again.
ID This column lists the slot numbers of the line cards. Click the ID number of an active DSL line
card to go to a screen where you can copy a DSL port’s settings to another DSL port.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to the
card starting, a firmware upgrade in progress or a malfunction. See Section 38.7 on page 1111
for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was started.
Firmware This field displays the current firmware version installed on the line card.
Table 107
VDSL Port Setup: Xvlan Setup (continued)
LABEL DESCRIPTION