ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 1000 / 1168

Chapter 33 switch Commands
Management Switch Card User’s Guide
1000
Three examples (show all MDs, a specified MD’s detail, a specified MA’s detail) are shown next.
33.6 switch dot3ad Commands
Use the
switch dot31d
commands to configure static and dynamic (LACP) port trunking.
33.6.1 switch dot3ad lacp priority Command
Syntax:
switch dot3ad lacp priority < priority >
where
This command sets the LACP system priority.
ras> switch cfm show
status : enabled
no. of maintenance domain : 2
md name level no. of ma
-------------------------------- ----- ---------
MD_0 0 1
MD_1 7 0
ras>
ras> switch cfm show MD_0
maintenance domain : MD_0
level : 0
no. of maintenance association : 1
ma name cciInterval primary vlan no. of MEP
---------------- ----------- ------------ ----------
L2SW-DSLAM 4 1 1
ras>
ras> switch cfm show MD_0 L2SW-DSLAM
maintenance association : L2SW-DSLAM
cci interval : 4
primary vlan : 1
no. of maintenance ep : 1
maintenance ep list : 1 2 1001
vlan list : 1
MEP id slot-port direction Priority cciEnabled
------ --------- --------- -------- ----------
1 enet1 down 7 enabled
mip: 2-22
< priority >
=
LACP system priority is a number between 1 and 65,535. The switch with the
lowest system priority (and lowest port number if system priority is the same)
becomes the LACP “server”. The LACP “server” controls the operation of LACP
setup. Enter a number to set the priority of an active port using Link Aggregate
Control Protocol (LACP). The smaller the number, the higher the priority level.