ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 1065 / 1168

Chapter 36 voip Commands
Management Switch Card User’s Guide
1065
sip cpt set < reorder > < howler >
< alerting >
MSC1024GC only. Sets the CPT (Call Progress Tone)
timer mode.
reorder
: re-order tone timeout. This indicates the
local, toll switching, or transmission paths to the office or
equipment serving the called customer is busy This
signal may indicate a condition such as a timed-out
sender or unassigned code dialed. Reorder tone timer
indicates that the duration of reorder tone (5~300s). The
default is 10s.
howler
: howler tone timeout. This informs a customer
that their receiver is off-hook for a while. Howler tone
timer indicates that the duration of howler tone (5~300s).
The default is 60s.
alerting
: alerting tone timeout. This is the ring signal
to inform caller and callee a phone call has been sent or
arrived. Alerting tone timer indicates that the duration of
alerting tone (60~1200s). The default is 600s.
8
show
MSC1024GC only. Displays the CPT status. 8
route delete < slot > default
|< ip-address >[/
< netmask >]
[ gateway ]
Removes the specified route entry of the specified
slot. 8
set <slot> default
|{< ip-address >[/
< netmask >]}
< gateway-ip >
[< metric >]
Configures a routing entry for the specified slot.
Each slot may have up to 16 routing entries.
ip-address :
The route IP address.
network mask
: 0 ~ 32 (default is 32)
gateway-ip:
The gateway IP
metric
: The metric number of the
route
: 1 ~ 15
name
: The name of the route.
8
show < slot >
Displays the routing table for the specified slot. 1
sip dialplan delete < name >
Removes the specified dial plan table.
name
: The dial plan table name (<32 characters).
8
map [< name >]
Displays the SIP protocol profile(s) that refer to
the specified dial plan table. 1
set < name > < pattern >
< number-of-prefix-
cut > < sip-server >
[< prefix-add-
digits > < number-
of-digits >
< interdigit-
timeout >]
Configures dialplan-related settings.
See Section 36.13.3 on page 1086 for more
information on this command.
8
show [< name >]
Displays the contents of the specified dial plan
table. 1
sip ip dns <
ip
>
Configures the SIP DNS server IP.
ip
: IP of domain name server, 0.0.0.0 indicate that the
system won’t use DNS resolving.
8
Table 390
voip Commands (continued)
COMMAND DESCRIPTION P