ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 197 / 1168

Chapter 8 Multicast Screens
Management Switch Card User’s Guide
197
Figure 119
Static MAC Multicast
The following table describes the related labels in this screen.
Table 81
Static MAC Multicast
LABEL DESCRIPTION
VID Type the number of the VLAN that incoming packets for this static multicast group must be
tagged with.
Group MAC Enter the static multicast MAC address.
Note: You can enter any IPv4 and IPv6 multicast MAC address here except the follows,
• 01:80:c2:00:00:00 ~ 01:80:c2:00:00:3f (for IEEE 802.1D MAC bridge filtered MAC
group addresses)
• 01:00:5e:00:00:00 ~ 01:00:5e:ff:ff:ff (for IPv4 multicast groups)
Type a VID and a group MAC and click Apply to display entries in the first table.
Index This column lists the slot numbers of the line cards. Click the number of an active line card to
go to a screen where you can set the membership of each of the card’s ports for this static
multicast group.
Card Type This field displays the kind of card installed in a slot.
Port This section lists the VLAN membership setting of each port on each line card. An “F”
indicates that the port is a permanent member of the static multicast group. An “X” indicates
that the port is forbidden (blocked) from joining the static multicast group. An “-” indicates
that the port is a normal member and can join the group dynamically.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
New After you click Apply , entries display in the first table so you can edit them. Click New if you
want to configure a different static multicast group.
Cancel Click Cancel to begin configuring the screen again.
Modify Select a static multicast group’s radio button and click Modify to display the static multicast
group in the table above so you can edit it.